Specifications

Enter Base Level: Press
ITCM,
then dial
#c
# 7 4 6
+c.
programming configuration as
discussed in the following
Dial
+#
# 7 4 6
%.
programming procedures, can be
defaulted to the factory settings all at
once using this
master clear
Press
+k
for base level
Press MNTR (SPKR).
Pause Time: During auto
speed dials it is sometime
to delay the sending of
digits
to
give
Press *for next feature.
switching equipment time to prepare to
receive the digits. A pause can be
stored to effect the delay. A pause is
stored whenever the user presses
!he
HOLD button. The pause length
options
are stored in seconds.
make/break
ratios for the pulse
dialing
signals (rotary dial signals) can be set
to match CO requirements.
Press
*
for next feature.
Press
46
for next feature.
been on hold for a programmed length
of time, the
system will recall the
Press prog. button.
Press
*
for next feature.
1
Press
2if
SPKR to end programming.
1