Specifications

Programming
IMI 66-031
d.
To enable origination by zone;
x.
1.
Press line select key 5 for zone A
2.
Press line select key 6 for zone 3
.-.
3.
Press line select key 7 for zone C
4.
Press line select key 8 for all-call
(if it was cleared in step b).
NOTE
Step 15 must be performed last. See previous important note.
15. Set the &&
B a w m only if current settings
are not correct.
When power was
initially applied to the KSU, the
system set the line appearance to key assignment so that line 1
matched select key 1,
line 2 matched select key 2, etc. (squared
pairing).
If this squared pairing is desired, skip step 15a and
b.
a.
Press the 7 i
0
key on the keypad.
A tone burst will sound.
There is no default condition set by pressing this key.
b.
Assign the pairing.
Any desired pairing can be set.
All line
select keys can be programmed to select the same line if such
a condition is desired.
(1) Press a line select key. A tone burst will sound.
3
(2) Press the keypad key that represents the line
to be paired.
Another tone burst will sound.
(3) Repeat this sequence for every line select key.
C.
Disable the line select key and the indicator light for any
lines which are unassigned to a particular station:
(1) Press the line select key for the unassigned
(2) Press the 9
key on the keypad.
(3) Repeat this action for each unassigned line.
16. Press the *i
0
key to return to the base programming
17. Repeat steps 1 through 16 for each station connected
line.
system.
18. Press the
0
MONITOR
key to exit the programming mode.
64
mode.
to the