Specifications
Programming IMI 66-031
‘I
6.
Enable the rlna,inn
0
1
dewi qweqya
for the station by pressing the
key on the keypad rf t is feature is desired.
7.
Set the ~&&JQ &J&J, &gst&ti+cre by performing the steps listed
below. At this point,
there are no toll restriction tables
assigned to this station.
a.
Press a memory key for each table to be assigned to the
station.
Tables 1 through 8 correspond to the memory keys 1
through 8.
A tone burst will sound with each selection.
b.
Proceed with step 8 if other station COS programming must be
performed.
If only programming the toll restriction
requirements of a station, proceed with step 16.
During an initial station programming sequence, perform all of the
remaining programming steps given herein (8 - 14).
It is recommended
that they be performed in the order that they are presented.
During
subsequent reprogramming of a station, any step, controlling a feature
that does not need to be reprogrammed, can be skipped over.
It is not
necessary to return to the base programming mode to shift from one
programming
step to another.
A default value is automatically
programmed for most of the following characteristics when the
selection key is pressed.
This default value is overridden by
subsequent programming action.
IMPORTANT NOTE
STEP 15, WHICH SETS THE
PROGRAMMING ACTION MUST
TO THE BASE PROGRAMMING
A line may be programmed for
ringing (step 9) but not for
direct ringing (step 8) or delayed
both ringing features.
If step 8 is
programmed after step 9 for some reason,
disabled.
delayed ringing will be
BE IMMEDIATELY FOLLOWED BY A RETURN
MODE.
8.
Set the a&
’
~&&&JJJ
for each line.
a.
key.
A tone burst yi
ringing enabled wil
\
1
soun
be se %
l
onAal%f??+i$s.
b.
Press the line select key for each line on which direct'
ringing is desired.
A tone burst will sound after each
selection.
9.
Set the &md J&J~ a&&&e for each line.
a.
Press the
ok
3
i
F ey.
A tone burst will sound.
A default
condition of no delayed ringing enabled will be set on all
lines.
b.
Press the line select key for each line on which delayed
ringing is desired.
A tone burst will sound after each
selection. The time of this delay is 15 seconds.
62