Specifications

Programming
IPlI 66-031
.P-
STATION COS
The Station COS programming sets the following station
characteristics:
DSS/BLF port enable
Ringing assignments
PA port enable
Access denied
Prime line selection
Call origination denied
Ringing line preference
Automatic privacy release
status
Station toll restriction
Night ringing assignment
All-call and zone paging
requirements
confiquration
Line appearance/key assignment
Enter the base programming mode:
The dial tone will sound.
Press a two-key sequence on the keypad which corresponds to the
station to be set (i. e.,to choose station 11 press
(l)al*
A tone burst will sound to confirm a proper selection. An
improper selection will result in the dial tone sound indicating a
return to the base level mode.
NOTE
Each time the base programming mode is followed by a station
select number,
the following features are set to the default
values:
the DSS/BLF port enable, the PA port enable, the
'prime line selection,
and the ringing line preference
enable. Plus,
the toll restriction table assignments are
disabled.
Set the ~&!~g.&~ s;sggg& ggg& g;e&&g (if such a port is required)
by pressing the
0
RECALL
key.
A tone burst will sound to
confirm the selection. Skip this step if a DSS/BLF console is not
installed at the station port currently being programmed.
If this
feature is enabled, do not proceed beyond this step unless the
port is also to be programmed as a PA port.
Set the a &&J&-L SQ&& (only if a PA port is desired) by pressing
0
9
y on the keypad.
A tone burst will sound to confirm this
Y
selection.
Skip this step if a PA port is not desired.
Do not
proceed beyond this step if a PA port selection is made.
Set a a~% ’
line select
P
for the station being programmed by pressing the
ey for
the line desired or by pressing the
0
ITCM
key
to select the intercom line.
A tone burst will sound
to confirm
the selection.
If more than one line selection key is pressed,
the last one pressed selects the accepted prime line.
61