Specifications

Programming
_
IMI 66-031 1
,
5.
Assign the line specific toll restriction tables per the following
procedure.
Atthis point,
31 toll restriction tables are
unassigned for the selected line.
c ,
a. Press a memory key for each table to be assigned to the line.
Tables 1 through 8 correspond to the memory keys 1 through 8.
A tone burst will sound with each selection.
b. Proceed with step 6 if other COS programming must be
performed.
If programming only the toll restriction
requirements of a line,
repeat step 5 until all lines are
programmed.
6.
Select the remaining line characteristics by pressing keys on the
keypad to choose them per the following chart.
A tone burst will
sound after each selection to confirm it.
I 0 I
LINE PORT DISABLED
I
LINE
TYPE
1
AUXILIARY PORT
I 2 I
TELCO PORT (DEFAULT VALUE) 1
3
PAHX PORT
. ..I
DIALING
I
MoDE 31 ’
I I
I 1
TIME INTERVAL FOR
8
50 MSEC.
LINE RESTORE AFTER
HOLD IS ABANDONED
9
300 MSEC. (DEFAULT VALUE)
7.
Repeat Steps 5 through 7 for each line.
8. Press the *i
0
key on the keypad.
The dial tone will sound.
9.
Press the
0
MONITOR
key to exit the programming mode.
60