Specifications

Programming
IMI 66-031
II
13.
14.
/- 15.
Press the
MONITOR
U
key to exit the programming mode.
maximum of 16 digits.
entered,
When the maximum number of digits are
the system sounds a fast ringhack dial tone and steps
to the next entry point on a table or to the next table.
e.
If less than the maximum number of digits are required as part
of a table entry,
select the next entry location with the
proper memory key.
input is required.
Select each entry location even if no
entry is erased.
This action insures that any previous
Erase a complete table, if desired, by
selecting the table and then selecting each entry location in
sequence.
Do not dial any numbers after any of the entry
location selections.
f.
Repeat steps a. through e.
until all toll restriction tables
are programmed.
Press the *f
0
key on the keypad.
The dial tone will sound.
Program the &b m bw w for
0
3:
keypad key to set a system data
0
0
i keypad key to set a system data
default condw sets a system data
the printer port.
Press the
speed of 300 baud.
Press the
speed of 110 baud.
The system
speed of 110 baud.
LINE COS
The Line COS programming sets the following line characteristics:
-Privacy status
-Line toll restriction requirements
-Line port type
-Dialing mode
-Time interval for held call abandon
1.
2.
-
3.
4.
Enter the base programming mode:
The dial tone will sound.
Set the amu &as Q& && &&a per the following steps.
a.
Press the
0
8
F
key on the keypad. The dial tone will stop.
This action initializes all lines aS private.
This condition
is the system default value.
b.
Press the line select key of each line which is to be
non-private.
A tone burst will sound after each selection to
confirm it.
The line status chosen will be in effect at every
station in the system.
Press the *z
0
key on the keypad. The dial tone will sound.
Press the line select key of the line to be set.
The dial tone
will stop.
The toll restriction tables currently assigned to the
selected line will be disabled when the line select key is
pressed.
59