Specifications

Introduction
IMI 66-031 ,
.
c
system defaults to system-wide,
all-call paging in zone D with all
stations having both receive and originate capability.
A station port can be programmed to interface with an external paging
amplifier.
It can be dial accessed from the other stations in the
system.
A line port can also be programmed to interface with an
external paging amplifier.
This paging amplifier can be accessed from
the stations in the system with the line select key.
DTMF tones can
be dialed through the line paging port to provide zone selection if
dialed zone selection is available at the external paging amplifier.
If an on-hold party hangs up at the TELCO/PBX end of the
communications link, causing an interruption in the tip/ring line
current,
the system will drop the line off of the hold condition and
return it for service. The line select indicator will turn off to
indicate an idle line condition.
If the intercom line is selected while an outside line call is active,
this system feature will cause the outside call to be automatically
placed on hold.
A system feature provides automatic privacy on all lines at every
station.
Automatic privacy prevents other stations from joining a
station on an active line unless that station user allows it.
Through
programming,
the system can be configured so that certain lines are .
normally non-private.
When the non-private line is in use at a
particular station,
users of other stations in the system can join
that station user on the non-private line.
This can be accomplished
by pressing that line select key on their station.
An automatic redial of the last dialed number is available at every
station.
A busy number or unanswered call is automatically redialed
by this feature.
Once automatic redial is selected, the station will
select a line,
automatically dial a number, and wait for a response.
It will do this once a minute for 10 minutes.
c
3