Specifications

Programming
IMI 66-031
SYSTEM COS
The System COS programming sets the following system characteristics:
-DTMF or pulse tone dialing
-System default conditions
-Type of signalling first attempted during an intercom call
-Time interval for a programmed pause used with auto/speed dial
-Parame.ters for pulse dialing
-Hookswitch flash time/dial tone recall interval
-Time out time interval for hold recall
-Toll restriction table entries
1.
Perform the base level program entry procedure:
Press the following keys
A dial tone will sound.
2.
Select the =a&$ a au au dialing system default
characteristics.
a.
Press the
0
#
F
key on the keypad.
confirm the selection.
The dial tone will stop to
0
?_
b.
Press the
0
8
R
key to select the TONE ONLY dialing condition or
press the 1
0
key to select the PULSE/TONE dialing condition. r_
A tone burst will sound to confirm the selection.
c. Press the *i
0
key on the keypad.
The dial tone will return.
In addition to setting the dialing mode, the above action causes the ,
system to default to a fixed set of operating conditions as follows:
54