Specifications

c
Operation
IMI 66-031 ’
SMDR AND COS PRINTOUT
U
When a data printer is connected to the printer port to print station
message detail recording (SMDR),
it can also be commanded to print the
class of service (COS) programming configuration for the System,
lines,
and stations.
Partial or complete printouts can be obtained.
When the printer is being used to obtain a COS printout, the SMDR
function is temporarily halted. SMDR data collection is continued by
the system during a COS printout operation; however, if more than two
calls are logged for any one line,
call records may be lost. Typical
COS and SMDR printouts are shown in Figure 7a and 7b.
Use the following procedure to obtain the COS printout.
1.
At Station 10, place the system in the base level program entry
mode.
a.
Press the
0
ITCM
key.
b.
Once the dial tone is heard, press the m key on the
keypad.
C. Press, in sequence,
keys.
A tone burst
programming mode is
them,the@),axe&keypad
will sound to indicate that the base level
entered.
d. Press the
0
74: key
and listen for dial tone.
:_i
2.
Press a memory key to select the type of printout desired per the
following chart.
I BUTTON I
PRINTOUT FEATURE I
9
10
11
PRINTOUT STOPS AT NEXT COS BREAKPOINT
COMPLETE PRINTOUT
PRINTS SYSTEM AND LINE COS PLUS TOLL
RESTRICTIONS
I -~- ~~ -
L. IT-n-1 n
12
1 PRINTS SELECTED STATION COS
I
KEYPAD KEYS 1 SELECT9 STATION (10-25) FOR COS PRINTOUT
3.
When a particular station COS printout is desired, follow the
memory dialing feature key operation by pressing km keys which
correspond to the desired station (e.g., press keys
to select station 12).
Oand @
4. COS printout will begin immediately.
Press the
0
MONITOR
key to
exit the base level program entry mode.
1
50