Specifications
Operation
IMI 66-031
_
_ --
f’:-
DIAL TONE RECALL/FLASH OPERATION
It iS sometimes convenient to have a line disconnect key to use when
making one call right after another.
When
custom calling
features are
not available from the host system,
the key
system can be programmed
to allow the RECALL
0
key to act as a positive disconnect key.
Dial tone' recall and flash operation are mutually exclusive.
The
system will be programmed to provide only one of these features.
When custom calling features are available from the host system, the
instructions for accessing them indicate that the user should first
execute a
"flash" operation.
Each station is equipped with a AECALL
0
key
which can be pressed to cause a precisely timed. flash signal to be
electronically generated.
Flash operation and dial tone recall are mutually exclusive.
The
system will be programmed to provide only one of these features.
AREA PAGING INTERFACE
If the telephone system includes the proper external paging equipment,
and a station is programmed to enable paging, it can be used to voice
address an area of the site in order to find, notify, or summon
someone.
A user can access this paging feature directly by pressing
the proper line select key and speaking into the handset. If zone
paging is available,
dial the proper zone code before speaking.
Paging'aCCess may require the use of the intercom and the dialing of a
2-digit code.
The system manager can provide complete details.
ALL-CALL AND ZONE PAGING - VIA STATION SPEAKERS
All Call And Zone Paging uses the station monitor speaker and handset
to receive and originate one-way messages.
Such messages could be
used to find, notify, or summon someone.
With this feature, a station
may be programmed to only receive a message; however, it may be
programmed to originate a message as well. Also, a station may be a
part of only one call zone,
a part of several call zones, or a part of
the system-wide all call.
The system manager determines the
capabilities of the stations.
Reception of all call and zone paging
messages are automatic.
If a station has message originating
capability,
it can be used to announce messages to other stations in
.
the system as follows:
1.
Determine to which zone the message is directed.
r-
43