Specifications
Operation
_
IMI 66-031
:
AUTOMATIC AND SPEED DIALING (STATION)
./T
A station is
equipped for both automatic dialing and speed dialing.
i
These features provide methods by which numbers can be retained for
easy retrieval.
Up to fourteen 150digit numbers in the automatic dial
g
ortion and up to ten 15-digit numbers in the speed dial portion can
e stored for retrieval.
An additional ten 310digit numbers can be
stored at station 10 and used by all stations for system-wide speed
dialing.
In the following paragraphs, the method of storing numbers
for use is the same for all types of dialing modes and is described
together; however,
the way that these features are used is somewhat
different and is described separately.
.
SfrdrlnOBgAlltauaBMBialm
A user may store a desired number as follows:
1.
2.
3.
.4.
5.
6.
Press the
0
ITCM
key,
and listen for the dial tone.
Press the
0
SAVE
key.
The intercom dial tone will stop.
Press a memory key for the automatic dial
number
to be stored or
press a keypad key (1-O) for the location code of the speed dial
number to be stored.
A tone burst will sound to confirm this
action.
If a specific line or intercom is to be stored as part of the
1
number, press the line select or intercom key corresponding to it.
A tone burst will confirm this selection.
This action is
optional.
If a specific line or intercom is not stored, the
system will automatically select the prime line (if available) or
the last line used to originate a call when automatically dialing
the number.
Dial the number sequence as if it were being dialed on-line.
A
pause can be stored by pressing the x key, and a
hookswitch flash can be stored by pressing the
RECALL
0
key.
up to
15 digits including the numbers, t's, f's, pauses, and flashes can
be stored at each location.
Repeat steps 2 through 5 for each desired automatic dial number or
speed dial number.
If the memory key 14 is programmed as an
automatic dial location,
the automatic redial feature normally
controlled by this key is disabled.
To restore the automatic
redial feature,
repeat steps 1 and 2, press key 14.
Press the
MONITOR
0
key,to end the procedure.
40