Specifications
.I
Operation
IMI 66-031
SHIFT
Press the HoLD
0
key and immediately press the SAVE
0
key.
The station will automatically turn on the monitor speaker: select
the station prime line, if available, or the last active line; and
dial the saved number.
2.
Listen for an answer or a busy tone.
Pick up the handset to
complete an answered call.
Press the
MONITOR
0
key to terminate a
busy or unanswered call.
AUTOMATIC REDIAL (OF BUSY NUMBERS)
An automatic redial of a busy number can be performed
by
a station
user.
This feature is available when the station is connected to a
line and a dialing operation has taken place resulting in a busy
signal or no answer.
Automatic redial is automatically disabled
whenever a memory dialing.feature is programmed at memory key 14 but
”
is
To
1.
automatically restored when the programmed feature is cleared.
use the automatic redial feature, proceed as follows:
When the busy number signal is heard
(AUTO REDIAL).
, press the memory key 14
Hang up the handset if off hook.
The
0
ITCM
light
will flash rapidly to indicate that automatic redial is active.
r
2.
3.
After a 1 minute wait,
the system will activate the station
monitor speaker,
reselect the line,
and redial the number.
If the
handset is not picked up or the MON,TOR key is not pressed
0
(because of a continued busy signal),
the line will be dropped
approximately 20 seconds after the number is completely dialed.
Automatic redial action will repeat ten times.
If the ringing
tone is heard, the handset must be picked up or the MON,TOR key
0
.
pressed to take control of the call.
The indicator will stop
flashing when this action is taken.
NOTE
On a s eakerphone,
ii
take control of a call either by pressing
the
MON,TOR key or by lifting the handset.
Although a
conversation can be established on a speakerphone without
taking control of the call, the line will be disconnected
within 20 seconds if control action is not taken.
Cancel the automatic redial by lifting and replacing the handset.
Any other use of the station while the automatic redial feature is
active will cancel further automatic redial action.
The indicator
will stop flashing when automatic redial is cancelled.
39