User guide

STATION SPEED DIAL PROGRAMMING
Station speed dial numbers can be stored by the
station user for later redial. The storage locations are
keypad digits 0 through 9 on the station. Before
attempting to program, decide on the following items:
(1) the number or feature to be stored, (2) which
storage location will be used (0 - 9), (3) the circuit that
the call will go over (individual line or intercom).
To program numbers,
•
Press ITCM SS2.
•
Dial a memory location (0 through 9).
•
Press specific line button or ITCM button to store
line or intercom preselection if desired (optional).
•
Dial the number sequence to be stored. (Up to 15
digits can be stored. Valid digits include 0-9, #, and
*.)
•
To store a pause if required, press HOLD.
•
To store a hookflash if required, press TAP.
Example: Store a telephone number under
location 0. The sample number is
1(804)555-2222. Program it as follows:
ITCM, *, *, 2, 0, Line Button, 1, 8, 0, 4, 5, 5, 5, 2,
2, 2, 2.
To store another number,
•
Press TRANS/CONF.
•
Press next speed dial location.
•
Make line pre-selection if desired.
•
Dial number for storage.
•
Repeat this procedure until all desired numbers are
stored.
To end station speed dial programming,
•
Press MNTR (SPKR).
DIRECT STATION SELECTION/BUSY
LAMP FIELD (DSS/BLF) PROGRAMMING
One-button intercom calling with visual indication of
telephone status can be programmed at telephone
buttons not assigned to lines. The DSS/BLF console
buttons are fixed by the system for DSS/BLF operation
beginning with station 10 and ending with the
maximum station number in the system.
To program DSS,
•
Press ITCM ** 3.
•
Press button to be programmed as DSS button.
•
Dial extension number.
•
Repeat last two steps for all desired extension
numbers.
To end DSS programming,
•
Press MNTR (SPKR).
NOTE: An autodial number can also be
programmed as a secondary function at
every DSS/BLF memory location. See
Automatic Dialing instructions for
programming details.
AUTOMATIC REDIAL BUTTON
PROGRAMMING
The system will allow the last previously dialed
number to be automatically and repeatedly redialed for
approximately ten minutes. A button must be
programmed to provide this feature.
To program a programmable button for use as an
automatic redial button,
•
Press ITCM SS1.
•
Press desired programmable button.
•
Press #.
•
Press MNTR (SPKR).
System Description IMI 66-064
5-9