Specifications

IMI 66-064
SYSTEM SPEED DIALING
To dial numbers,
System Operation
l Press ITCM and dial paging code.
HINTz Program a softkey with ITCMplus the paging
l Press f.
l Press desired ke
locations 1 throug iY
pad digits 01 - 30 for memory
30.
-OR-
code to provide one-key access to paging.
l Dial code for zone paging if required (refer to paging
equipment instructrons).
@ If on line listening to dial tone.
l Press HOLD +Ic and then press desired keypad
digits 01 - 30.
VOICE ANNOUNCE BLOCKING
To block voice calls,
l Lift handset, make announcement, and hang up.
ALL-CALL AND ZONE PAGING
To Paw,
l Press ITCM.
l Lift handset.
l Press ITCM.
l Dial t 2
To un-block voice calls,
l Press ITCM.
l Dial # 2.
LINE MONITORING
To activate while using handset on a call,
l Dial zone number - (4, 5, 6, or 7 for all-call).
l Make announcement.
l Hang up handset.
DO NOT DISTURB
To silence a station ringer and appear busy to in-
tercom calls,
0 Press SPKR. Speaker light will turn on.
l Hang up handset.
NOTE: If a distant parfy places a station user on hold, the
station user can monitor in a handsfree manner
until the party returns, and then lift the station
handset to resume the call.
To cancel,
l Press SPKR. Speaker light will turn on.
NOTE: The calling party will hear two quick tone bursts
every three seconds. rile feature cannot be over-
ridden by the calling party.
To cancel,
Press SPKR again. Speaker light will turn off.
l Lift handset to resume conversation
-OR-
. ;;ss SPKR to disconnect. Speaker light will turn
TAP (RECALL/FLASH)
Flash (PBX, CENTREX and custom calling services
may require this feature.)
MUTE / HANDSFREE ANSWER INHIBIT
The MUTE key is in a non-latching mode when the
station,handset is lifted and in a latching mode when the
station is operated in a hands-free manner.
To prevent distant party from hearing while hand-
set is lifted on a call,
l Press and hold MUTE. SPKR light will flash.
To resume two-way conversation,
If a system has been configured for flash,
l Press TAP to generate a timed flash signal.
Recall
l Release MUTE. SPKR light will turn off.
To prevent distant party from hearing while station is
being operated in a hands-free manner,
-OR-
If a system has been cohfigured for recall,
l Press TAP to disconnect current line call and receive
a new dial tone for another line call.
NOTE: A system can be configured for either flash or
recall but not for both.
EXTERNAL PAGING
(requires external paging unit)
l Press line key dedicated to paging.
-OR-
To inhibit handsfree answer of intercom calls,
l Press and latch MUTE. SPKR light will flash.
To resume two-way conversation,
l Press and release MUTE. SPKR light will turn off.
PULSE/TONE SWITCHING
If the local telephone service is pulse (rotary) but tone
generation is required during the call, convert to tone
while dialing as follows:
l Lift handset.
5-4