Specifications

Ii.4 66-064
System Operation
FEATURE OPERATION
REDIALING
Last Number Redial
The last number previously dialed can be redialed.
l Press #. (If on line listening to dial tone, press HOLD
w
l Listen for ringing or busy tone.
l Ringing tone: When party answers, pick up
handset.
l Busy tone: Press SPKR to disconnect.
Automatic Redial
The last number previously dialed can be redialed
repeatedly.
To program a softkey for automatic redial,
l Press ITCM.
l Dial~~l.
l Press desired softkey.
l Press #.
l Press SPKR.
To activate automatic redial,
l Press softke
listening to cy
programmed forthat purpose (if on line
ial tone or busy tone, ress HOLD then
P
ress auto redial key). Intercom kg twill flash rapidly
R
o indicate feature is active.
l Number will be dialed once a minute for ten minutes.
If call is answered,
l Take control by lifting handset.
To cancel automatic redial,
l Press auto redial key, lift and replace handset, or
press any station key. Any user originated station act
WIII cancel this feature.
AUTOMATIC DIALING
An autodial number can be programmed at any softkey
location that does not have a line assigned to it. An
autodial number can also be programmed as a secon-
dary function at every DSS/BLF memory location.
To program autodial numbers,
l Press ITCM.
l Dial%+Kl.
l Press desired softkey. Listen for fast tone bursts.
l Listen for fast tone bursts.
l Press specific line ke
tion storage (optional .
ry
or ITCM for circuit pre-selec-
NOTE: When automatic dialing is used and no circuit pre-
selection is programmed, the system will automat-
ically pick the prime line assigned to the telephone
(if enabled) or pick the most previous/y used line
at that station.
l Dial the number sequence to be stored. (Up tc 15
digits can be stored. Digits can be l-0, #, and +)
l To store a pause, press HOLD.
l To store a flash, press TAP.
To store another number,
l Press T/C.
l Press next softkey.
l Repeat above programming procedure beginning
from softkey selection step.
To end programming,
l Press SPKR
H/NE Store intercom line pre-selection plus often-
used, host PBX or CENTREX feature access
dialing codes at memory locations to provide
one-key access to system features.
To automatically dial numbers,
l Press desired softkey.
-OR-
@ If desired softkey is also programmed for one-key
intercom calling,
l Press HOLD and then press desired softkey.
’
When party answers,
l Lift handset.
STATION SPEED DIALING
To program numbers,
l Press ITCM.
l Dial 4~ 4~ 2.
l Follow same steps given for Automatic Dialing using
the keypad digits 0 - 9 as ten softkey locatrons.
To dial numbers
l Press desired dial pad digit 0 - 9.
-OR-
* If on line listening to dial tone,
l Press HOLD and then press desired keypad
digit 0 - 9.
5-3