Specifications

, Enter Base Level: Press ITCM, then dial k # 2 3 6 %.
‘Pause Time: During. auto dials and
‘speed dials it is sometimes necessary
todelay the sending of digits to give
switching equipment time to prepare to
receive the digits. A pause can be
stored to effect the delay. A pause is
stored whenever the user presses the
HOLD key. The pause length options
are stored in seconds.
Pulse Dial Time: Either ten or twenty
pulses per second, and three different
make/break ratios for the pulse dialing
signals (rotary dial signals) can be set
to match CO requirements.
Recall/Flash: A line disconnect (recall)
or a PBX feature select signal (flash)
can be generated depending upon the
programmed time.
Timed Hold Recall: After a call has
been on hold for a programmed length
of time, the system will recall the
station that placed the call on hofd.
The timing is fn seconds.
Dial 10.
Press prog. key.
Press * for next feature.
Dial 11.
Press prog. key.
Press * for next feature.
Dial 12.
Press prog. key.
Press t for next feature.
Dial 13.
Press prog. key.
Press +N for next feature.
SHADING = DEFAULT
KEY 1 Al A2 A3 A4
62/36 @’ 20 ps RATIO &I36 m, lO&bs 50/50 @ 10
ENTRY 1
pps 70130 @ 10 pps
KEY Al A2 A3 A4 A5
A0 A9 A10 All Al?
SEC 060 ENTRY’ ’ 300 .500 .600 .750 ,675 1.0 1.5 2Jk ,, 3.0
1 Press % SPKR to end programming. 1