Specifications

Programming Instructions

IMI 66-064 ’

SECTION 2

CLASS OF SERVICE

PROGRAMMING ,/

Class of service programming is usually performed by

the system installer. Class of service programming

procedures provide a means for programming all

system variables. The installer may elect, however, to

program only the line attributes and allow the

remainder of the system variables to remain set to

their default values.

Perform class of service programming as follows:

Enter base level: ITCM % # 7 4 6 %

0 (Optional step) Master Clear: Dial 15, press A12,

dial 7 0 5 1 6 8 4

This step clears all memory entries,

including any previously programmed

autodialnumbers, and returns system to

start-up default.

Mark the desired selections in the charts to record

programming needs.

0 Dial feature code.

NOTE: A current program setting is indicated by a

lighted LED next to the applicable progamming

key. When a toggle (on/oft’j action is provided

by a single key, the lighted LED indicates when

the feature is active.

0 Press A-field key to choose new programming.

8 Press % to return to base level for next feature.

-OR-

* Press % SPKR to end programming.

4-4