Specifications

PN: 1725-36132-001_E.doc

Interface Implementation

This section describes the recommended programming in order to use

the SpectraLink Wireless Telephone System or SpectraLink 8000

System components with a Comdial Digital Telephone System. The

procedures assume the following:

• The Comdial system is installed and operational in an approved

configuration. See the Telephone Switch Interface Matrix document

for tested configurations.

• A trained Comdial technician will be on site with the Installer to

program the system.

• The SpectraLink 6000 System or SpectraLink 8000 Telephony

Gateway is installed and the handsets are available for

programming.

Set the Switch Interface Type

SpectraLink 6100 MCU

The SpectraLink 6100 Master Control Unit requires the switch

interface type to be configured using the front panel buttons. The

configuration procedures are detailed in the SpectraLink 6100 MCU:

Installation and Operation document.

SpectraLink 6300 MCU

When configuring the SpectraLink 6300 MCU, the PBX interfaces are

available as sub-menu selections when defining the Interface Module

type using the SpectraLink 6300 MCU Operator’s Console. Refer to

the SpectraLink 6300 MCU: Operator’s Console document for details on

configuring the Interface Modules.