Specifications

Plan the Interface
PN: 1725-36132-001_E.doc
11
the handset menu displays, allowing the first press of the FCN key to
access softkey functions. See SpectraLink 6000 System, SpectraLink
6300 MCU: Operator’s Console for further procedural information.
Another option may be to disable the softkey menu at the system
level and exclusively use the SpectraLink menu. This would remove
any unwanted interaction, but might restrict the number of available
features to the number of programmable keys on the handset.
SpectraLink 6100 MCU
For the SpectraLink 6100 MCU, the handset function menu can only
be changed via remote configuration through the services of
SpectraLink Customer Support.
SpectraLink 8000 Telephony Gateways
Menu options can be changed in the Administration Console of the
SpectraLink 8000 Telephony Gateways. The Delay function is used
when the PBX uses softkeys. With Delay, when the
FCN key is
pressed, the handset displays the features that are associated with the
softkeys so that one of these features can be selected first. If Delay is
programmed, pressing the
FCN key twice will bring up the menus
immediately. Under the menu programming section of the
Administration console there is an option to use Delay (same as the
SpectraLink 6300 MCU). See the SpectraLink 8000 Telephony Gateway:
Administration Guide for SRP document for further details. Also refer
to the same document for details on configuring the telephone switch
type
Hold
The Hold feature should be programmed to the Hold key as shown
on the key-map diagrams so that when the
HOLD key or softkey is
pressed on the handset, the call is placed on hold.
Mute
The handset Mute function is hard-coded to FCN +1 on the PTB4xx
handset. This function sequence is recommended, but the system
administrator can assign the Mute function to any available function
key sequence or leave the function unassigned. The SpectraLink 6000
and SpectraLink 8020/8030 Wireless Telephones use a
Mute softkey.