Specifications

DXP Correspondence Manual

System

Programming

Button Map Default

Every programmable button at each telephone connected to the system

provides line selection, direct station selection, or other functions.

Programming action for a particular station assigns a function to each

button. You can create unique button function assignments, known as

button mapping, at each station. This default erases all unique button

function assignments. Personal speed dial numbers and

autodial

numbers are cleared with the button map default action.

Line Default

Each line can have individually configured operating conditions. The

line default sets these conditions to the default parameters.

Tables Default

Various system-wide operating features depend upon tables of

information to control their parameters. These tables are

programmable to let the features match a broad range of site

requirements. This table default procedure resets the following

programmable tables to the default conditions: SOHVA tables, toll

restriction tables, ARS route tables, modify digits tables, and account

code verify tables.

Remember, the system erases all programmed entries when you take

this defaulting action.

DID Translation Table Default

If you have programmed translation tables for DID use (see sections

8.22 and

8.23),

you can clear them with this procedure.

Clear System Status Log

If you have enabled system status reporting (see section 5.12) at a

station, you can turn off its status light by using this procedure. Use

the system printout information in section 13 to view the status report

before turning off the light at the status reporting station.

DXP Correspondence Manual