Specifications

Installing The

DXP

DXP Correspondence Manual

3.10

Testing The

Stations

Power up the DXP and take a voltage measurement across each signal

pair on the type-66 station block. The appropriate voltage

measurements are also shown on charts in

IMI66-085.

To test the stations, plug in the digital station and check to see that the

LCD appears (if applicable). Once the LCD comes up, perform a

station self-test:

unplug the telephone,

press and hold the 1 key as you plug the telephone back in

(mute key on analog, such as

ExecuTech,

telephones).

If all of the

LEDs

light in sequence and the telephone rings, the

station is working.

Finally, seize an intercom line and make a call. Complete the

call to make sure that you have two-way communication.

Make sure that any Scout

9OOMX

digital wireless telephones are all

fully charged before you place them in service. Also check your

industry-standard telephones. Plug the station in, and make sure

that

you hear a dialtone. Make sure that the IST stations ring when called,

to ensure that the ring generator is working properly.

12 Installing The DXP