Specifications

DXP Correspondence Manual
Automatic Route Selection
Route
12.4
Tables
The ARS feature interacts with the toll restriction feature. You must
enter a number into the toll restriction table and assign a route table
(l-32) to that number before the system can perform ARS. The
system will route only those numbers that you have assigned a route
number and entered on the toll restriction table. The route table entry
specifies the following parameters:
I
-over what line group the call will route,
-whether the station is permitted to make a call on that group,
-whether the dialed numbers must be modified to
match that line group.
If a dialed number is not matched by an entry in the toll restriction
table, it is routed by route table 32-the default route table. The
system defaults table 32 to use line group 16 and it defaults line group
16 to use all lines. You must either remove all invalid lines from line
group 16 or make table 32 inactive if you do not need default routing.
The entered numbers can be some of the same numbers that you enter
as toll restriction numbers or additional numbers. You can enter a
maximum of 400 toll restriction and/or ARS numbers. Each entered
number can be up to 16 digits long and can be comprised of digits O-9
plus the “match any” digit (0) if needed.
NOTE: When the system accepts a number entry into the toll restriction
table, it re-orders all of the table entries. The system places a 0
after all other digits in the entries. Also, it places a number with a
leading 1 ahead of the same number without a leading 1.
Automatic Route Selection 12 - 3