Specifications

Automatic Route Selection DXP Correspondence Manual
12.2
ARS Enable
12.3
Line Groups for
ARS
You can enable or disable automatic route selection on a system-wide
basis. A defaulted system has ARS disabled.
Before automatic route selection can operate, you must group similar
lines together into line groups. The system can have a total of 16 line
groups with unlimited lines in each group.
Be sure that you program similar line types together into the same line
groups to take advantage of the efficiency and cost savings associated
with automatic route selection. Some examples of lines that have
similar characteristics and should be grouped together into line groups
are as listed below:
-outgoing WATS lines to a particular area,
-FX lines to a frequently called area,
-similar AT&T long distance lines,
-similar MCI lines,
A line group can consist of only one line, (for example, if only one FX
line exists) to allow the ARS feature to route calls over that group (FX
line) for any calls to the FX line area.
NOTE: To prevent system users from accessing non-AR,!3 line groups, use
section 5.15, Feature Renumbering, to clear the dialing codes for
all non-ARS line groups.
12 - 2 Automatic Route Selection