Specifications

Add, Remove, Display Account Codes
Use this procedure to assign up to 1000 account codes (each up to 16
digits in length-see Section 10.3.3). Alternately, use this procedure
to remove previously assigned account codes from the system. Add or
remove one account code at a time or an entire block of account codes
all at once. To assign numbers that user’s can dial without entering an
account code, refer to section 10.4.
Account Code (For Class Of Service)
After you have enabled the account code feature for the system, set its
parameters, and programmed its list of account codes into the system,
turn the feature on for a station class of service and make it either
forced or optional. If you make it a forced account code, the user must
enter an account code before the system will let him or her dial the
number for an outgoing call. Also, on incoming calls a user must enter
an account code before the system will allow him or her to make any
future outgoing calls (see section 6.2, Account Codes, for more
information).
10 - 6 SMDALSMDR Programming