Specifications

DXP Correspondence Manual SMDALSMDR Programming
Account Code (System Parameters)
Account codes are used to identify calls by category, so that the
system can record costing by that category. You can arrange the
system to force the user to enter an account code and have the system
verify it before it allows the user to make a call. Turn on the account
code feature for the entire system using this procedure. Also, enable or
disable system verification of the entered code. If you enable
verification, the system compares the account code entered by a
station user with the programmed account code entries that you have
assigned. If the system does not find a match and you have enabled
the forced account code feature through station class of service, the
system prevents any further dialing until the user enters a matching
account code. If you have not enabled verification, the system does
not check the entered account code for a match. See section 10.3 for
further account code programming details.
Account Code Display And Account Code Display Time
As a feature to LCD speakerphone users, a message appears in the
telephone’s display to prompt the user to enter an account code during
incoming and outgoing calls. If the system does not require such a
prompt (for example, because the account code feature is disabled),
turn off the prompting message display with this programming
operation. If the system does require the prompting display and you
enable it using this procedure, also set the length of time that the
prompt shows on the user’s display. See section 10.3 for further
account code programming details.
NOTE: When the account code display is on, the user must enter
an account code within the display time when he or she is
making an outgoing call; otherwise, the system will drop
the line.
Account Code Length
An account code can be a minimum of three digits or a maximum of
16 digits. Use this procedure to set the number of account code digits.
See section 10.3 for further account code programming details.
NOTE: If you change the account code length, you will delete
all currently programmed account codes.
SMDABMDR Programming 10 - 3