Specifications

DXP Correspondence Manual Line Programming
8.10
Program the line port to match either a DTMF tone or a rotary (pulse)
Dialing Mode
dialing line as supplied by the central office (CO).
Pulse Dial Make/Pulse Dial Break (Pulse Dial Ratio)
Use this procedure to set the make/break ratio for rotary dial signaling
to match rotary dial line requirements. You can set the line
make/break ratio for rotary dial (pulse dial) signaling in a more
flexible manner to match many different rotary dial line requirements.
You can set the make time and the break time independently in one
msec. increments to any time from one to 99 msec.
Pulse Dial Interdigit Time
You can set the interdigit time between dial pulses when the system
pulse-dials a number over a line. The DXP defaults this time to 200
msec. and provides a range of timing values between 100 msec. and
one sec. that you can set in 100 msec. increments.
Line Programming (Page 2)
1. Dialing Mode
: Tone
2. Abandon Hold Release
:350 MS
3. Pos. Disconnect Time :2 Set
4. Toll Groups :l
5. DTMF Level : Normal
6. Busy Lead :No
7. Disconnect Supervision :No
8. Caller ID Active
:No
9. Voicemail ID :
10. DISA :No
11. DISA Voice Options :4
The Station Menu-screen two
Line Programming 8 - 7