Specifications

DXP Correspondence Manual Sys tern Programming
System Manager Password
The default system manager station entry code is as follows: .
INTERCOM button, +k # 746 SC. You can change the default password
portion of this station entry code (the 6 portion) to a custom value of
up to 15 digits. Thus, a new station entry could be as follows:
INTERCOM button, +k #74 nnnnnnnnnnnnnnn %.
You can also change the feature code portion of the system manager
station entry (the ?k#74 sequence). You can change the feature code
from I+#74 to a custom code of up to four digits (no letters allowed).
Thus, a new system manager entry could be as follows: INTERCOM
button, nnnn 6 S. Further, if you couple the allowed password change
with the allowed feature code change, a system manager station
programming entry code could be as follows: INTERCOM button,
nnnnnnnnnnnnnnnnnnn + (for information on changing this feature
code, see section 5.15, Feature Renumbering).
Attendant Password
The default attendant station entry code is as follows: INTERCOM
button, +k #0 SC. The feature code part of this entry is the +H#O
sequence. You can change the feature code from the HO code to a
custom code of up to four digits (no letters allowed). Thus, a new
attendant entry could be as follows: INTERCOM button, nnnn +k (for
information on changing this feature code, see section 5.15, Changing
The Feature Codes).
NOTE: The new feature code must not conjlict with existing dialing
codes. Either choose a different feature code or use the
programming procedure titled Feature Renumbering to
renumber any dialing codes that conflict.
DXP Correspondence Manual 5 - 35