Specifications

System Programming
DXP Correspondence Manual
Camp-On/Automatic Call Back Ring
After you enable a call waiting tone (see section 6.9), use this .
procedure to set the duration of the camp-on/automatic ringback ring
that the system sounds when it returns a camp-on call to the original
station.
Out Dial Delay Time
The system will wait for a programmed length of time before sending
automatically dialed numbers over an outside line. This delay gives
the host system time to return dial tone before the system begins
dialing the number. Different host systems require different periods of
time between when a line is picked up and when dial tone is returned.
Use this procedure to match this system to your host system.
Authorization Code Time-out
After you have enabled the authorization code feature (see section
10.2), you must set the authorization code time-out. Once a user uses
the authorization code to access his or her telephone features, those
features remain in effect until any idle time at the telephone exceeds
the authorization code time-out period; use this feature to program that
time-out period.
IST Ring Time-out
Use this procedure to set the number of times that the system sends a
ring signal to an industry-standard telephone on a system-wide basis.
Although the ringing stops at the industry-standard telephone when
the time-out occurs, the system continues to present the call at the
telephone for answering until the caller abandons it.
IST DTMF Receiver Time-out
You can program the amount of time that the system waits to receive a
DTMF tone from an industry-standard telephone, after the user has
lifted the telephone’s handset and before he or she has pressed a dial
pad digit. The system disconnects the telephone after this time-out
occurs. If this disconnection occurs, the user must hang up the handset
and lift it again to re-establish the dial tone.
5 - 24 DXP Correspondence Manual