Specifications

DXP Correspondence Manual
Sys tern Programming
Internal Interdigit Dialing
A timer starts running with the dialing of each digit during intercom
number dialing. It also starts running whenever the user accesses the
intercom number path and does not dial any digits. When the timer
“times out,” the system returns the station to an idle state. Use this
procedure to set the intercom dialing time-out period for the entire
system.
Maximum Line-To-Line Connect Duration
After you have given a station the ability to set up an unsupervised
conference between two lines (see section 6.36), you should use this
procedure to set the maximum amount of time that an unsupervised
conference can continue. When the time out occurs, the system recalls
the station from where the user enabled the unsupervised conference.
System Timing (Page 2)
1. Internal Interdigit Dialing
2. Max Line-Line Connect Time
3. Camp-on/Auto Callback Ring
4. Out Dial Delay Time
5. Authorization Code Time-out
6. IST Ringing Time-out
7. IST DTMF Receiver Time-out
8. IST Minimum Flash Time
9. IST Maximum Flash Time
10. Voicemail DTMF Tone
11. Pulse Dial Interdigit
12. Pulse Dial Make (ms)
13. Pulse Dial Break (ms)
CTRL N for next gage. CTRL P for previous
The System Timing Menu-Page Two
DXP Correspondence Manual 5 - 23