Specifications

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-30
Operation
1. After a CO line call has been made and the distance party is busy, hang up.
2. Press
!78. The extension will access a CO Line or CO Line group and dial the last number dialed.
3. The display will show the current attempt cycle and the total number of attempts for which the system has
been programmed.
Conditions
a) The Feature Code !78 can be programmed under a flexible feature button on the digital
speakerphone to be used with the Auto Redial feature.
b) If a Flexible Feature button has been programmed for use with Automatic Redial, the button may be used to
invoke the feature. While the feature is active the LED of that button will be lit steady red. During dialing
attempts the LED of that button will flash red.
The system will continue redial attempts until:
• Call rings through and caller picks up,
Or...
• The maximum number of attempts is reached,
Or...
Any other feature is used on the telephone.
The number of redial attempts and the timed interval between attempts are set in system programming and
are not changeable at the extension level.
If all extension accessible CO Lines or the CO Line group are busy at the time of an Automatic Redial
attempt, that attempt will count as a valid attempt and reduce the remaining number of attempts.
Default Setting
Attempts is set at 8 seconds
Interval is set at 60 seconds
Waiting Time is set at 15 seconds
Programming Abstract
Adjust timers as required.
Programming via the DET (Digital Extension Terminal)
Note: [back
backback
back], [next
nextnext
next], [show
showshow
show], [chg
chgchg
chg], [bksp
bkspbksp
bksp], and [save] are interactive LCD button operations. Use the
three buttons below the LCD display to actuate the associated operation.
• Enter Database Administration using the feature code
!#* and then enter the DB Admin password
“
########.” (Note: This eight-character password can be changed.)
• Press [
show
showshow
show]. The DB Item Select screen displays.
• Input 03-31 to program Auto Redial.
• Press [save
savesave
save]. This advances to the Call Handling – Automatic Redial database item.
• Press [
show
showshow
show] to enter into these data items.
• Use the [back
backback
back] and [next
nextnext
next] interactive buttons to select the appropriate data item to be changed. Available
data items in Auto Redial are: “Attempts,” “Interval,” and “Waiting Time.”
• When the appropriate data item for change displays press [
chg
chgchg
chg].
• “Attempts” will allow any number to be entered from 0-2. (Note: “0” disables Auto Redial.)
Ø When the number has been entered, press [
save
savesave
save]
• “Interval” may be selected from the following choices: 30, 60, 90, 120. Each time that [
chg
chgchg
chg] is pressed
the selection is incremented through the available choices.