Specifications

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-255
• Press [
next
nextnext
next] to continue programming the various call handling digits (Prefix/Suffix).
• Press
the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
06-02-1~3-03 (VM Table – Delete Digit, where 1~3 = Tenant Group)
• Press [
save
savesave
save].
• Press [chg
chgchg
chg].
• Input the digits required to delete the current recording in this subscriber MB.
• Press [save
savesave
save].
• Press [
next
nextnext
next] to continue programming the various call handling digits (Prefix/Suffix).
• Press
the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
06-02-1~3-03 (VM Table – Disconnect Digit, where 1~3 = Tenant Group)
• Press [
save
savesave
save].
• Press [chg
chgchg
chg].
• Input the digits required to force disconnect of the active port.
• Press [save
savesave
save].
• Press [next
nextnext
next] to continue programming the various call handling digits (Prefix/Suffix).
• Press
the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
03-33-01 (VM Dialing Ratio – Tone Time)
• Press [
save
savesave
save]. This advances to Call Handling – VM Dialing Ratio – Tone Time.
• Press [chg
chgchg
chg] until the appropriate Tone Time displays.
• Press [next
nextnext
next] to program Inter-Digit Time. Or…
• Press
the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
03-33-01 (VM Dialing Ratio – Inter-Digit Time)
• Press [
save
savesave
save]. This advances to Call Handling – VM Dialing Ratio – Inter-Digit Time.
• Press [chg
chgchg
chg] until the appropriate Inter-Digit Time displays.
• Press
the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu. Then press
«.