Specifications

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-235
Operation – Supervised Transfer
1. While connected to a call (CO Line or intercom extension):
a. Press the Transfer button.
b. Dial the extension destination directory number where this call is to be transferred.
Or...
a. Press the feature button programmed for the destination extension number.
2. Wait for the called extension to answer the intercom call. Announce the transfer.
3. Hang up (go on-hook) to complete the transfer.
Analog Ports (Single Line Telephones)
1. While connected on a call (CO Line or intercom extension), press {FLASH} (hook switch flash).
2. When you hear dial tone, dial the destination to which you want to transfer the call (extension, UCD Group,
Virtual Number, etc.).
3. To screen the call, wait for the called extension to answer. Otherwise, hang up to complete the transfer.
Conditions
a) Transferred CO Lines that recall are placed on system hold at the time the recall occurs.
b) When a transferred CO line recalls, the line number and extension number where the call was transferred
will be displayed.
c) The transferred connection party will hear ring-back tone while the call is transfer ringing.
d) CO Line calls and intercom calls may be transferred.
e) In screened transfer, if the destination extension answers your intercom call in Voice Announce Hands-free
mode and does not go off hook, the transferred connection will transfer ring at that extension.
f) In screened transfer, if the destination extension answers your intercom call by lifting the handset, the
transferred connection is connected to the destination extension immediately when the transfer operation is
complete.
Default Settings
Call Handling – XFR_I Recall (Transfer – Idle Recall) is set to “30” seconds.
(Range is 16/30/60/90/120 seconds.)
Call Handling – XFR_B Recall (Transfer – Busy Recall) is set to “60” seconds.
(Range is 16/30/60/90/120 seconds.)
Programming Abstract
Program the recall time for calls that are transferred to an Idle Extension and for calls that are transferred to
a Busy Extension.
Programming via the DET (Digital Extension Terminal)
Note: [back
backback
back], [next
nextnext
next], [show
showshow
show], [chg
chgchg
chg], [bksp
bkspbksp
bksp], and [save
savesave
save] are LCD interactive button operations. Use the
three buttons below the LCD display to actuate the associated operation.
• Enter Database Administration using the feature code !+* and then enter the DB Admin password
“
++++++++.” (Note: This eight-character password can be changed.)
• Press [
show
showshow
show]. The DB Item Select screen displays. (All database programming items are indexed for fast
access. Note: Press the volume up or down bar to return to the DB Item Select screen at any time.)
• Input 03-10, then press [
save
savesave
save]. This advances to the Transfer-Idle Recall programming screen.
• Press [
chg
chgchg
chg] until the appropriate value for this data item displays.
• Press [
next
nextnext
next] to advance to the next data item or exit programming.