Specifications

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-230
Program Digit Interval(s) and assign Extension/CO Line COS to Digit Intervals:
• Input 05-01-1~3-001~100 (where 1~3 is the Tenant Group and 001~100 is the Interval to program). Then
press [
save
savesave
save]. This advances to the “FROM” column of the tenant group and interval selected.
• Press [chg
chgchg
chg] to change the start of this interval range (beginning FROM…).
• Input the new starting digit sequence, then press [save
savesave
save].
• Press [
next
nextnext
next] to advance to the “TO” column of the tenant group and interval selected.
• Press [
chg
chgchg
chg] to change the end of this interval range (up …TO).
• Input the new ending digit sequence, then press [save
savesave
save].
• Press [next
nextnext
next] to advance to Extension or CO Line COS as required for change.
• Press [show
showshow
show]. The DAY Allowed parameter displays for the Extension or CO Line COS.
• Press [
next
nextnext
next] to advance to the EVE Allowed COS for the Extension or CO Line COS.
Or…
• Press [
show
showshow
show] to program COS allowed settings for this Digit Interval. COS 0 displays.
• Press [next
nextnext
next] and [back
backback
back] until the appropriate COS to change displays.
• Press [chg
chgchg
chg] until the appropriate setting (Y/N) displays.
• Press
the Hold button to return to the previous menu level.
Or…
• Press the Volume button (up or down) to return to the DB Item Select screen.
Program Extensions for the COS to follow:
• Input 01-101~156-05~06 (where 101~156 is the Extension and 05 is DAY Class Of Service and 06 is EVE
Class Of Service.)
• Press [
chg
chgchg
chg] until the appropriate COS displays for the selected service mode.
• Press
the Hold button to return to the previous menu level.
Or…
• Press
the Volume button (up or down) to return to the DB Item Select screen.
Program CO Lines for the COS to follow:
• Input 02-740~755-04~05 (where 740~755 is the CO Line and 04 is DAY Class Of Service and 05 is EVE
Class Of Service.)
• Press [
chg
chgchg
chg] until the appropriate COS displays for the selected service mode.
• Press
the Hold button to return to the previous menu level or press the Volume button to return to the DB
Item Selection screen or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.