Specifications

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-227
Program Tenant Group Calling:
• Input 03-29. Then press [
save
savesave
save]. This advances to Tenant Calling.
• Press [show
showshow
show].
• Input the Tenant Group for which changes are to be made. Then press [show
showshow
show]. The display shows the status
of
calling allowed settings from this tenant group to the tenant group displayed.
TO TENANT 1:Y
back next chg
• Press [chg
chgchg
chg] to select “N” if calling to this tenant group is to be denied.
Or…
• Press [next
nextnext
next] to skip to the tenant group to program.
• Press
the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu. Then press
«.
Program extensions into the tenant group:
• Use
¢£¤¥ to highlight “Extension” and then press «.
• Use
¢£¤¥ to highlight “Category 1” and then press «.
• Use ¢£¤¥ and ³´ to highlight “Tenant Group” for the appropriate extension to program.
• Press
« until the appropriate tenant group number displays.
• Use ¢£¤¥ and ³´ to highlight “Tenant Group” for the next extension to program and continue as
above until all extensions are programmed in the tenant groups.
• When all changes are made press the ° (escape) key to exit this database programming screen. You will
see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press
° (escape) again to return to the Database Programming menu.
Program CO Lines into the tenant group:
• Use ¢£¤¥ to highlight “CO Line” and then press «.
• Use
¢£¤¥ to highlight “Category 1” and then press «.