Specifications

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-219
To program SPD No. Assignment (allocation):
• Use
¢£¤¥ to highlight “SPD No. Assignment” and then press «.
• To allocate speed numbers in the System List:
• Use
¢£¤¥ to highlight “System List” and then press «.
• Use ¢£¤¥ to highlight the Tenant Group speed dial allocation under either the Increase or
Decrease column.
• Press « to increment the selected Tenant Group speed number allocation. Each time that enter is
pressed allocation is incremented by 50.
• When all changes are made press the ESC (escape) key to exit this database-programming screen.
You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
Ø Press “N” to abort changes and leave all data unchanged.
Ø Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
Ø Press “N” to abort changes and leave all data unchanged.
Ø Press “Y” (yes) to continue with the save operation.
• To allocate speed numbers in the Individual List:
• Use the cursor arrows to highlight “Individual List” and then press
«.
• Use the cursor arrows to highlight the extension speed dial allocation under either the Increase or
Decrease column. (Use the
³ or ´ buttons to select extensions not viewed on this screen.)
• Press « to increment the selected Tenant Group speed number allocation. Each time that enter is
pressed allocation is incremented by 10.
• When all changes are made press the ESC (escape) key to exit this database-programming screen.
You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
Ø Press “N” to abort changes and leave all data unchanged.
Ø Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
Ø Press “N” to abort changes and leave all data unchanged.
Ø Press “Y” (yes) to continue with the save operation.
To program SPD Numbers:
Note: Both System and Individual Speed numbers can be programmed via PC-DBA.
• Use
¢£¤¥ to highlight SPD No. Programming then press «.
To program System SPD Numbers:
• Use
¢£¤¥ to highlight System SPD No. then press «.
• Use
¢£¤¥ to highlight the Tenant Group for which changes are to be made, then press «.
• Use
¢£¤¥ and the ³´ buttons to select the System Speed Dial number to change.
• Press
«.
• Input the new telephone number with special characters as required.
Pause = “P”
Flash = “/” (forward slash button)
Speed Numbering Chaining = “@” + next speed number (500-699).
• Press
«.
• Use
¢£¤¥ and the ³´ buttons to select the System Speed Dial number to change.
• Use the conventions above to program other speed dial numbers.