Specifications

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-218
• Press [
show
showshow
show], this advances to the Increase screen for this Tenant Group System Speed List.
• Press [chg
chgchg
chg] to increase the number of allocated speed dial numbers (in increments of 50).
Or...
• Press [
next
nextnext
next] to advance to the Decrease screen for this Tenant Group System Speed List.
• Press [chg
chgchg
chg] to decrease the number of allocated speed dial numbers (in increments of 50).
• Press [
next
nextnext
next] to input a new Tenant Group and continue programming.
• Press
the Hold button to return to the previous menu level or the Volume button (up or down) to return to
the DB Item Select screen.
To program System Speed Numbers:
• Input 04-09-1~3, then press [
save
savesave
save]. This advances to the System Speed Dial entry point for the Tenant
Group selected.
• Input the speed dial number to program (500-699), then press [
show
showshow
show]. The current stored number displays.
• Press [chg
chgchg
chg] to change this stored number.
• Input the new telephone number with special characters as required.
Pause =
!70
Flash = !3
Pulse-To-Tone Conversion = *.
Speed Numbering Chaining =
! + . + next speed number (500~699).
• Press [
save
savesave
save]. The speed dial number and the new contents are displayed.
• Press [next
nextnext
next].
• Input the next speed dial number to change and follow the conventions above.
Or...
• Press the
Hold button to exit this programming and return to the previous menu level.
Then…
• Continue making other programming changes or exit the programming mode.
• Press
the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu. Then press
«.
• Use ¢£¤¥ to highlight “System Resource” and then press «.