Specifications

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-118
Conditions
Only one Letter Scheme can be active at one time.
Default Settings
System Application – Letter Type: is set to “0.” (Range is: 0-7.)
Programming Abstract
Program the Letter Type for the special character set available via numeral 1 (dial pad digit key) for Name in
Display.
Programming via the DET (Digital Extension Terminal)
Note: [back
backback
back], [next
nextnext
next], [show
showshow
show], [chg
chgchg
chg], [bksp
bkspbksp
bksp], and [save
savesave
save] are LCD interactive button operations. Use the
three buttons below the LCD display to actuate the associated operation.
• Enter Database Administration using the feature code
!+* and then enter the DB Admin password
“
++++++++.” (Note: This eight-character password can be changed.)
• Press [
show
showshow
show]. The DB Item Select screen displays.
• Input 08-02, then press [save
savesave
save]. This advances to the LETTER TYPE programming screen.
• Press [chg
chgchg
chg] until the value for this data item displays.
• Press the Hold button to exit DISA programming and return to the previous menu level.
• Press the Volume button (up or down) to return to the DB Item Select screen.
• Continue making other programming changes or exit the programming mode.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu. Then press
«.
• Use ¢£¤¥ to highlight “System Application.” Then press «.
• Use
¢£¤¥ to highlight “Category 1.” Then press «.
• Use
¢£¤¥ to highlight “Letter Type.”
• Press
«. Each time you press «, the value of this database item is updated. Use the table to determine
the specific Enhanced Letter Type for this application.
• When you have completed all changes, press the
° (escape) key to exit this database programming
screen. You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press
° (escape) again to return to the Database Programming menu.
• Continue making other programming changes or exit PC-DBA programming.