Specifications

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-100
Cable
• Connection to the DX-80 system on site is accomplished via the PC serial port (COM Port). Use a straight-
through 9-pin to 9-pin cable to from the PC serial port to the DX-80 CPM – PC-DBA Port. Once this
connection is made, it is possible to connect to the DX-80 system processor and download (receive) DX-80
database memory to the PC-DBA
working directory.
Modem
• See F9-Modem below. This connection method can be used while off-site.
Connecting to the DX-80 processor
• Once a physical connection (cable or modem) has been made between the PC and the DX-80 system. You
must link the two devices using the F5-Connect function. See the details below.
• When a successful connection has been established between the DX-80 processor and the PC PC-DBA
software the following icon displays in the upper left corner of the PC-DBA screen:
[Cnt]
Sending data
• Since PC-DBA programming edits the data files of the DX-80 in the PC working directory only, it is
necessary to send this information from the working directory to the DX-80 system memory.
• Press F4. The options for what data to Send are displayed:
+------------------+
¦ Send Request ¦
+------------------¦
¦ * Send All ¦
¦ * Send Part ¦
¦ * Send Item ¦
+------------------+
• Use ¢£¤¥ to select from list - which send technique you desire. When Send All is selected, the data
exchange is started immediately. When Send Part or Send Item is selected, you must chose either the
specific data item (Item) or data category (Part) you wish to send. Use
¢£¤¥ to select from the
menus provided with these two functions.
Note: We recommend that whenever database changes are made to a system that has been in operation
for some extended period of time, a Receive All operation should be performed prior to any database
changes. Since some database fields including Speed Dial and Service Mode are user adjustable, these
fields might be erased if a Send All operation is performed using an outdated PC-DBA database.
F5 – Connect
Connecting to the DX-80 processor
• Once a physical connection (cable or modem) has been made between the PC and the DX-80 system. You
must link the two devices using the F5-Connect function.
• Press F5. If an adequate connection exists between the DX-80 system and the PC you will see the following
Connect prompt:
+----------------------------------------------------------------------+
¦ Connect ¦
+----------------------------------------------------------------------¦
¦ (1) : Receive Data From KSU ¦
¦ (2) : Don't Receive Data From KSU ¦
¦ Please Select : ¦
¦ Note : To select (1) will receive [Numbering Plan],[Ext DIR No.] ¦
¦ [CO Group DIR No.],[User Password] from KSU automatically, ¦
¦ so these data you set previously on PC will be lost. ¦
¦ To select (2), the data about 'DIR No.','User Password' on ¦
¦ PC may be inconsistent with KSU. ¦
+----------------------------------------------------------------------+
• Select “1” to receive the database items listed at the time of connection.
• Select “2” to connect to the system processor without an automatic data receive operation.