User guide

EP100G-L12 / EP100G-I12 User
Feb ‘05 Comdial 91
3. If the called station does not answer or is busy, select TRACK.
4. Hear a confirmation beep (tracker page accepted) or hear busy
a tone (tracker page not accepted).
5. Press the SPEAKER button to end.
Note: Tracker parked calls recall to your station after a pre-
programmed time-out. You can either place the call into
another Tracker page orbit or retrieve the call.
To retrieve a call that you parked using the Tracker option, perform
the following steps.
1. Press HOLD button to scroll your held calls (display shows
PA G E and extension number of each parked call).
2. Press TAP to retrieve the displayed parked call.
If you receive a parked call message on your Tracker pager, perform
the following steps.
1. Go to any system station.
2. Press INTERCOM.
3. Dial the Tracker pager orbit code (#800 to #899).
4. Retrieve the call.
To enable or disable a Tracker pager at your station, perform the fol-
lowing steps.
1. Press INTERCOM.
2. Dial #07 to enable, or dial #06 to disable.
3. Press SPEAKER to end.
7.6 Auxiliary/Headset Jack
The EP100G-L12 speakerphone is equipped with an auxiliary jack
that provides an interface for a headset, a tape recorder, an external
ringer, or an external pager. You must program one of its program-
mable buttons to serve as an enable/disable button for each auxiliary
device you plan to connect. The system activates only the device that
it identifies in the display, and activates only one device at any time.