User guide

EP100G-L12 / EP100G-I12 User
Feb ‘05 Comdial 87
To enable DND, proceed as follows.
1. Select OPTIONS.
2. Select Programming.
3. Select Do Not Disturb.
4. Select Do Not Disturb interact
button to toggle between ON and
OFF.
5. Select EXIT.
To disable the DND condition,
REPEAT the previous procedure, but select OFF instead of ON at
step 4.
To set a Do Not Disturb condition at
your endpoint when a call rings at your
station, perform the following steps.
1. Hear ringing and notice the
incoming call information in dis-
play.
2. Select OPTIONS.
3. Select Programming.
4. Select Do Not Disturb.
5. Select the Do Not Disturb inter-
act button. Ringing stops, the caller hears the do not disturb
tone, and your endpoint remains in DND until you disable the
feature.
6. Select EXIT.
7.4 Automatic Redial
If your station has the multiple automatic redial feature enabled, you
can place up to ten numbers in your endpoint’s redial queue.
Note: The AUTOMATIC REDIAL button must be programmed by
your system installer or system administrator. Individual users can-
not program this feature.