User guide

EP100G-L12 / EP100G-I12 User
Feb ‘05 Comdial 83
To respond to an alert after it sounds,
choose one of the following.
• Select CLEAR to turn off the alert.
• Select SET to reset the alert for
the same time the following day.
6.5 Response Message Button
You may program a RESPONSE MESSAGE button, which allows you
to send an LCD message to a caller who has initiated a SOHVA or
intercom call from another EP100G-L12, or to send an LCD message
to another EP100G-L12/EP100G-I12 that you call and receive a busy
signal or no answer.
To store a fixed RESPONSE MESSAGE button (delivers the same
message each time it is pressed), perform the following steps.
1. Select OPTIONS.
2. Select Programming.
3. Select NEXT until the Feature Button option appears.
4. Select Feature Button.
5. Select the programmable button you wish to use as a response
message button.
6. Select NEXT until the Response Message option appears.
7. Select Response Message.
8. Select from the list of displayed messages. Select NEXT to
scroll through the list of messages. If you use the Back at or
Call options add to them as follows:
• For the Back at message, dial the code for the time numbers
and colon from dialing codes table.