User guide

Other Advanced Features
100 Comdial Feb ‘05
7.12 Automatic Set Relocation
(EP100G-L12 only)
If your installer has equipped your EP100G-L12 with automatic set
relocation, when you move your endpoint to a new location, the
system gives you a choice (through a display prompt) as to whether
you want to keep your previous programming or use the pro-
gramming in the new location.
To maintain the extension number and programming features from
the old location, perform the following steps.
1. Connect the endpoint line cord to the new jack.
2. Observe the flashing HOLD light and press HOLD while the
light is still flashing. Your endpoint immediately assumes the
features from the previous location.
Note: If you do not select a button after installing the end-
point, the system automatically defaults to the programming
from the previous location.
To assume the extension number and programming features from the
new location, perform the following steps.
1. Connect the endpoint line cord to the new jack.
2. Observe the flashing HOLD light and dial # while the light is
still flashing. Your endpoint immediately assumes the features
from the previous location.
7.13 Paging
Your system provides an all-call or a zone page feature that you
access by dialing special codes. This arrangement sounds your voice
announcement through the endpoint speakers or through an external
paging unit.
To send a paging announcement, perform the following steps.
1. Lift the handset.