Installation Guide

ManualsBrandsCombiSteel ManualsFloor DrainCombiSteel 7075.0120 Horizontal Outlet Floor Drain

Table Of Contents

 

MODEL: 7075.0120 P: 1/4 )

PLEASE CHECK AND MAKE SURE THAT THE BELOW LISTED PARTS ARE SUPPLIED

PART NAME QUANTITV





 





 







200x200





















SECTION A-A







Summary of content (4 pages)

PAGE 1
( HORIZONTAL OUTLET FLOOR DRAIN INSTALLATION MODEL: 7075.0120 PLEASE CHECK AND MAKE SURE THAT THE BELOW LISTED PARTS ARE SUPPLIED PART NAME QUANTITV NO 1 2 3 4 BODY GRATE FILTER ELEMENT RUBBER PLUG 1 1 1 1 IT IS RECOMMENDED TO KEEP THE GRATE AND THE FILTER ELEMENT AWAV FROM THE INSTALLATION AREA UNTILL FINISHING THE FLOOR COVERING. 200x200 T"'" T"'" LO O') ----- 0160 0 0 C'\I r--.. SECTION A-A LO r-,...
PAGE 2
( HORIZONTAL OUTLET FLOOR DRAIN INSTALLATION MODEL: 7075.0120 P: 2/4 ) * THE DISTANCE BETWEEN THE TOP OF THE EXISTING CONCRETE AND THE ANTICIPATED FINISHED FLOOR LEVEL SHOULD BE EQUAL TO THE TOTAL HEIGHT OF THE FLOOR DRAIN. IN CASE THIS DISTANCE IS MORE, FOUR PIECES OF MS BOLTS AND EIGHT PIECES OF MS NUTS SHOULD BE OBTAINED AND USED AS ADJUSTING FEET. THE LENGTH OF THE BOLTS WILL BE SPECIFIED ACCORDING TO THE AFOREMENTIONED DISTANCE.
PAGE 3
( HORIZONTAL OUTLET FLOOR DRAIN INSTALLATION MODEL: 7075.0120 P: 3/4 * THE FLOOR DRAIN IS CONNECTED TO THE PVC PIPE. PLEASE MAKE SURE TO HAVE THE REQUIRED SLOPE AND THE ANGLE OF FLOW. .. ----------SLOPED ! 0 1 1 be� 0 1 1 ------+1 ----- 1 1 1 0 1 1 0 " � * APPROXIMATELV 30-40 MM OF CONCRETE IS POURED AT THE BOTTOM OF EACH FOOT AND LEFT TO CURE. MAKE SURE THAT THE FLOOR DRAIN IS KEPT UNTOUCHED TILL THE CONCRETE IS PROPERLY CURED.
PAGE 4
( HORIZONTAL OUTLET FLOOR DRAIN INSTALLATION MODEL: 7075.0120 * THE WHOLE GAP AROUND AND UNDER THE FLOOR DRAIN SHOULD BE FILLED WITH CONCRETE GRADUALLY AND HAVE A SMOOTH TOP SURFACE. * AS THE LAST STEP, TILING IS APPLIED • * THE WHOLE SURFACE OF THE FLOOR DRAIN MUST BE CLEANED PROPERLY BEFORE PLACING THE FILTER ELEMENT AND THE GRATE. * PLEASE MAKE SURE THAT THE RUBBER PLUG IS ALWAYS ON. THE RUBBER PLUG MAY BE TAKEN OFF FOR MAINTENANCE ONLY.