Installation Guide

ManualsBrandsCombiSteel ManualsDrainage ChannelCombiSteel 7075.0115 Horizontal Outlet Drainage Channel

Table Of Contents

HORIZONTAL OUTLET DRAINAGE CHANNEL INSTALLATION

PLEASE CHECK AND MAKE SURE THAT THE BELOW LISTED PARTS ARE SUPPLIED

PART NAME

QUANTITV

BODY

GRATE

FILTER ELEMENT

RUBBER PLUG

IT IS RECOMMENDED TO KEEP THE GRATE AND THE FILTER ELEMENT AWAY FROM THE

INSTALLATION AREA UNTILL FINISHING THE FLOOR COVERING.

1368

      







 



 b



 

-=











/

 

1 '



1 \ \

\ \ 



 I 11















�

 









�p 























684 684

  









MODEL: 7

115 

P: 1/4















i 





















SECTION A-A

Summary of content (5 pages)

PAGE 1
HORIZONTAL OUTLET DRAINAGE CHANNEL INSTALLATION MODEL: 7075.0115 1 P: 1/4 PLEASE CHECK AND MAKE SURE THAT THE BELOW LISTED PARTS ARE SUPPLIED PART NAME QUANTITV NO 1 2 3 4 BODY GRATE FILTER ELEMENT RUBBER PLUG 1 3 1 1 IT IS RECOMMENDED TO KEEP THE GRATE AND THE FILTER ELEMENT AWAY FROM THE INSTALLATION AREA UNTILL FINISHING THE FLOOR COVERING. 1368 A 300 1 co LO -.;f" C") 0 -.;f" ..- i IIN HII 1 1/ t::-::: // [/'.;.; b /, '/1.v '/ Il u / " \:'� \\ \ -= 1 " IC::::::"- ,.
PAGE 2
( HORIZONTAL OUTLET DRAINAGE CHANNEL INSTALLATION MODEL: 7075.0115 I P: 2/5 * THE DISTANCE BETWEEN THE TOP OF THE EXISTING CONCRETE AND THE ANTICIPATED FINISHED FLOOR LEVEL SHOULD BE EQUAL TO THE TOTAL HEIGHT OF THE DRAINAGE CHANNEL. IN CASE THIS DISTANCE IS MORE, FOUR PIECES OF MS BOLTS AND EIGHT PIECES OF MS NUTS SHOULD BE OBTAINED AND USED AS ADJUSTING FEET. THE LENGTH OF THE BOLTS WILL BE SPECIFIED ACCORDING TO THE AFOREMENTIONED DISTANCE.
PAGE 3
( HORIZONTAL OUTLET DRAINAGE CHANNEL INSTALLATION MODEL: 7075.0115 * THE DRAINAGE CHANNEL IS CONNECTED TO THE PVC PIPE. PLEASE MAKE SURE TO HAVE THE REQUIRED SLOPE AND THE ANGLE OF FLOW.
PAGE 4
( HORIZONTAL OUTLET DRAINAGE CHANNEL INSTALLATION MODEL: 7075.0115 I P: 4/5 ) * APPROXIMATELY 30-40 MM OF CONCRETE IS POURED AT THE BOTTOM OF EACH FOOT AND LEFT TO CURE. MAKE SURE THAT THE DRAINAGE CHANNEL IS KEPT UNTOUCHED TILL THE CONCRETE IS PROPERLY CURED.
PAGE 5
( HORIZONTAL OUTLET DRAINAGE CHANNEL INSTALLATION MODEL: 7075.0115 I P: 5/5 * THE WHOLE GAP AROUND AND UNDER THE DRAINAGE CHANNEL SHOULD BE FILLED WITH CONCRETE GRADUALLV AND HAVE A SMOOTH TOP SURFACE. * AS THE LAST STEP, TILING IS APPLIED • * THE WHOLE SURFACE OF THE DRAINAGE CHANNEL MUST BE CLEANED PROPERLV BEFORE PLACING THE FILTER ELEMENT AND THE GRATE. * PLEASE MAKE SURE THAT THE RUBBER PLUG IS ALWAVS ON. THE RUBBER PLUG MAV BE TAKEN OFF FOR MAINTENANCE ONLV.