Owner`s manual

SR PROBLEM OBSERVED PROBLEM CAUSE ACTION TO BE TAKEN

SUSPENSION

1. Abnormal or excessive Tyre out of balance Check balance and/ or

tyre wear adjust if required.

Steering geometry disturbed Adjust steering geometry.

Tyres not adequately inflated Adjust tyre pressure.

Wobbly wheel or tyre Replace wheel or tyre.

Defective tyre Replace tyre.

Hub play not proper Replace bearing.

Brake grabbing Check & rectify.

Excessive braking Modify driving habit.

2 Abnormal noise from Damaged struts or mounting Repair mounting or repair

front end strut

Worn suspension arm Replace

bushings

Loose wheel bolts Tighten wheel bolts

Loose suspension bolts Tighten suspension bolts or

or nuts nuts

Excessive hub play Replace bearing.

3. Ride too soft/ bumpy Faulty struts Replace struts

4. Suspension bottoms Over loaded Check loading

Faulty struts Replace struts

AC / HVAC

1 Blower motor does not Blown Fuse Replace Fuse and correct

operate any disconnection in wiring

Faulty connection Secure all connections

properly.

Faulty motor Replace motor if no

conductance

Faulty or poor connection at Replace resistor block if

found defective

Faulty fan switch Replace Switch

2 Motor operates but air Obstruction in the evaporator Clean Evaporator

flow is minimum inlet

Air Leak Seal correctly.

3 Insufficient Heating Air Leak Seal correctly.

Kinematic linkage damaged Get the defect rectified at

nearest authorized service

center

PRELIMINARY TROUBLE SHOOTING