Owner's Manual

- 5 -
Unbuckling the Harness
1. Press levers down on right and left harness hooks to
detach shoulder straps from buckle tongues.
2. Press center buckle button down while gently pulling
buckle tongues from buckle to release.
1. Unhook the shoulder straps from the center buckle as shown in figure a.
2. Pull the seat cushion forward while removing the shoulder
straps from the cushion as shown in figure b.
3. To raise the height, thread both shoulder straps through the
upper two loops. To lower the height, thread the shoulder
straps through the lower two loops as shown in figure c.
4. Thread the shoulder straps through the appropriate slot
of the seat cushion depending on which height the straps
are set at as shown in figure d.
WARNING: Ensure guardrail is securely attached by lifting up each
side of guardrail gently. NEVER lift the stroller by the guardrail.
Using the Harness
figure a
figure b figure c figure d
Harness Height Adjustment
Using the Guardrail
Attaching: Push the guardrail onto the guardrail posts on the
armrest until they lock in place. Ensure each side is firmly attached.
Removing: Press the buttons on each side of the armrest while
pulling the guardrail away from the armrest to remove.
WARNING
Avoid serious injury from
falling or sliding out. Always
use the 5-point harness.
Buckling the Harness
1. Place the crotch belt between the baby’s legs.
2. Insert buckle tongues into each side of buckle.
3. Lift buckle with tongues inserted and attach right
and left harness hook to holes in buckle tongue.
4. To adjust the harness or waist belt, loosen the slack
on both sides of each buckle and adjust to desired position.