Owner's Manual
Rear-Facing
Tether Attachment Strap
Installation and Use Instructions
IMPORTANT NOTE:
Tether Attachment Strap is for use with Combi
car seats only and only these models
specifically recommended by Combi USA.
Tether Attachment Strap
• Only use Tether Attachment Strap for rear-facing
tether installation.
• Only use Tether Attachment Strap with Combi
car seats.
• Secure the Tether Attachment Strap as shown in
this instructions sheet.
• Secure and adjust the top anchor strap provided
with this child restraint when installed rear-facing
as specified in this instruction sheet. Follow steps
in instruction manual for forward-facing tether
use.
WARNING - DEATH or SERIOUS INJURY
can occur
Use the Tether Attachment Strap to create a tether anchor
point for use with the car seat rear-facing. The Tether
Attachment Strap must be installed at the base of the vehicle
seat in front of the rear-facing car seat. In vehicles where
available locations for tether anchor point are too large to wrap
the Tether Attachment Strap around, the rear-facing tether
cannot be used. Store Tether Attachment Strap on car seat
with tether.
NOTE: Top tether use is recommended for rear-facing when
possible.
When not in use, store Tether Attachment Strap on car seat
with top tether.
KEEP THIS INSTRUCTION SHEET WITH THE CAR SEAT INSTRUCTION MANUAL
FOR FUTURE USE.
1. Move vehicle seat forward if necessary to expose to the
vehicle seat track and other vehicle mounting hardware
(closest to the center of the vehicle).
2. Select a fixed location on the inboard vehicle seat track or
other mounting structure that is bolted to the floor of the
vehicle and that the Tether Attachment Strap can be
wrapped around and secured to. If a location is not easily
identified, contact the vehicle manufacturer for a suggested
location to secure the Tether Attachment Strap.
3. Slide the metal
plate of the Tether
Attachment Strap
under the vehicle
seat track or
structure (fig. 1).
4. Slide the metal plate
through the sewn
loop (fig. 2).
5. Pull on the metal
plate to tighten
the Tether Attachment
Strap in place (fig. 3).
6. Use round hole
in metal plate as the
tether attachment
point for rear-facing
installation.
(fig. 1)
(fig. 2)
(fig. 3)
1
2
3
5
2
1
3
4
4
5
Tether Attachment Strap Installation