Owner's Manual

Reassembly of shoulder harness straps:

• To prevent ejection in a crash, the sewn loops on the

shoulder harness straps MUST be properly attached to

the metal harness plate.

• To prevent loose harness and risk of ejection, harness

shield MUST be in place during use.

• To prevent slack in harness and potential ejection in a

crash, the shoulder harness straps must be routed

through harness slots at the same height in the pad and

seat back.

Attachment of shoulder harness straps.

1. Pull out on shoulder harness strap to make

sure it is not twisted.

2. Slide end of shoulder harness strap through

harness slots at required height in seat pad,

foam, and seat back (fig. r). Pull all excess

strap through seat back.

3. Repeat for other shoulder harness strap.

(fig. r)

WARNING - DEATHor SERIOUS INJURY can occur

CCS0210G (EN) 061711.qxd:CCS0210G (EN) 061711 6/17/11 2:24 PM Page 59