Owner's Manual

Place car seat forward-facing in the vehicle
seat location selected with forward-facing
belt path toward vehicle seat back and
centered between the vehicle lower
anchors (fig. f).
Position car seat so forward-facing contact
zone is flat on vehicle seat bottom and seat
back is in contact with vehicle seat back
(fig. f).
Connect lower anchor connectors to vehicle
lower anchors.
- Position red release button of Push-On Connector
facing away from car seat and wording on
back side of of connector facing car seat.
If connector is not in this position, turn
connector over.
- Position the slot of the Push-On Connector onto
the vehicle anchorage. Push connector in to lock
onto the vehicle anchorage (fig. g). You should
hear a click.
- Pull on connector to be sure it is
locked onto the anchorage .
- Repeat for connector on opposite
side.
Locate the tether anchor (fig. h) for the seating
location being used.
NOTE: Check vehicle owners manual for
tether anchor location. DO NOT use
cargo tie downs or other attachment
points not intended for use with
car seats.
7
8
1
(fig. g)
1
2
2
37
(fig. f)
(fig. h)
Tether
Anchors
6
Upper
Shoulder
Belt
Guide
Lower
Shoulder
Belt
Guide
9
Slot
Forward-Facing
Contact Zone
CCS0210G (EN) 061711.qxd:CCS0210G (EN) 061711 6/17/11 2:24 PM Page 38