Owner's Manual

Check recline angle of car seat. Recline

reference line on side of seat MUST be

horizontal (fig. j). If recline reference

line is not horizontal, readjust or place

tightly rolled up towel, blanket or firm

foam (pool noodle) under end of car seat

base contacting vehicle seat back (fig. j).

If car seat cannot be adjusted to make

line horizontal:

1. Try a different LATCH equipped seating position.

2. Try installing using the vehicle seat belt. See

“Rear-facing Installation With Vehicle Seat Belt” section.

3. Do not use this car seat.

NOTE: Vehicle must be parked on horizontal

surface and child in car seat when

checking recline angle of car seat.

Secure tether attachment strap if possible. See “Tether

Attachment Strap Installation” section (fig. k).

Attach tether hook to tether attachment strap if

possible and adjust tether to remove slack.

Check for secure installation. Gripping car seat at

top of armrest, pull car seat front to back and left to

right to check for secure installation (fig. k). LATCH

belt MUST stay tight and child restraint should not

move more than 1 inch in any direction.

- If LATCH belt does not stay tight or car seat cannot be

securely installed, try a different LATCH location or use

the vehicle’s seat belt to secure the car seat.

Recheck recline angle of car seat. Adjust if necessary.

Re-snap and re-hook pad cover onto car seat.

BELT

HERE

Towel or

Pool Noodle

(fig. j)

Recline

Reference

Line

BELT

HERE

(fig. k)

CCS0210G (EN) 061711.qxd:CCS0210G (EN) 061711 6/17/11 2:24 PM Page 26